Fuel Injector Sleeve Cup Puller Installer Kit Compatible with Ford 6.0L/6.4L Powerstroke Installer Set O-rings
Application: Fit Compatible with Ford 6.0L/6.4L powerstroke diesel engine 2003~2010.
Package: 1*Electrical Connector Remover Tool, 1*Sleeve Installer, 1*Puller(Complete Fuel Injector Seal Kits).
Using Steps:
1. Thread the tap portion into the injector cup then crank the bolt down.
2. Put the removal it into the injector cup and holds them onto the cup, then tighten the nut on the tool to pull the cup out.
3. Place the injector cup over the end of the installer then place it back into the injector hole and hammer it until you hit solid ground.
Note:
These injector cups are made of hard steel and tend to be difficult to tap, when the tap becomes damaged or worn over time, you can purchase an inexpensive tap at the local hardware store as opposed to replacing an expensive and not-readily-available special tool. By installing this 6.0 Powerstroke injector cup tool, you’ll also be provided with an o-ring to retain the injector sleeve to the installer.